custom cooke cutters
Before Christmas I made and 3D printed three custom cookie cutters: one of Santa, one of my face and one of Pennsylvania. The outlines were the cutting part and then the inside was meant to emboss the shapes into the dough. They worked pretty well except the dough itself spread out too much when it was baked so it lost some of the resolution. More flour and less butter next time.
January 20th, 2012 at 11:13 am
I like your cookie cutters!
p.s. it is nice to see you blogging again!
January 24th, 2012 at 10:26 am
These are sweet. I totally need one of the PA/PGH ones! You could sell those on Etsy or something.
On a related note, if you haven’t seen this before, you should check out: http://www.jewelrynat.com/